88HatchMonster Posted March 29, 2008 Share Posted March 29, 2008 I'm putting an AWD 5MT from a 93 Legacy into an 87 hatchback so I've got to fab a new tranny crossmember. I'm not worried about the fab part, what I am wondering is how best to physically position the tranny so it's in the proper location relative to the axles and engine while I fit and build the crossmember? It will be going behind an EJ motor. All I can think of at the moment is to put some reference marks on the frame rails as to the position of the stub axles on the stock tranny, then swap trannies and line the new one up with those marks... Seems like this would work if I'm careful with the measurements, I'm just wondering if there's just some real simple easy fool proof way to do this that I'm not thinking of? Link to comment Share on other sites More sharing options...
kingbobdole Posted March 29, 2008 Share Posted March 29, 2008 This may not work for you, but when I put the EJ everything in my 88 3 door EA82 car, I used the stock front piece with the center section of the legacy H added to the center. Before After Done Link to comment Share on other sites More sharing options...
suberdave Posted March 29, 2008 Share Posted March 29, 2008 i did the same but that was in an EA82 not a hatch. worked awesome... -=Suberdave=- http://www.suberdave.com Link to comment Share on other sites More sharing options...
2K4 STI Posted March 30, 2008 Share Posted March 30, 2008 Would this be the same using the WRX crossmember instead of the legacy one? Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now