Clutch part compatibility

[TeamCF]

So I'm gathering parts to do a 5 speed swap.

But it's gonna take a little longer (proly swap it sometime this winter) than I want to wait to have my Roo back on the trails before the swap can begin.

So until then I've gotten a new clutch to get it going again.

(Been about 15 years since I've done a clutch, the Roo looks easy as pie though. )

 

 

So my question.

 

Can I just get a new disc that matches the 5 speed and use the rest of the parts in the new kit (I just bought) when I put the 5 speed in?

 

Or am I going to be buying a whole new kit for the 5 speed?

 

My Roo is an EA81 4 speed D/R. (225mm clutch)

 

I'm getting a D/R 5 speed with flywheel, clutch (of unknown condition), driveshaft.

Probably gonna lift it some when I do the swap.

 

After thinking about it.

I'd proly have to switch the pressure plate as well to be the same as the disc. Think I answered my own question.

[scoobyclimbs]

here's a linky..for Jerry's kit http://www.ultimatesubaru.org/forum/showthread.php?t=77255&highlight=jerry%27s+kit

 

 

 

Don't forget the driveline is longer for the 5spd swap the trans is shorter...Jerry can fill in the details when you call him..

[TeamCF]

here's a linky..for Jerry's kit http://www.ultimatesubaru.org/forum/showthread.php?t=77255&highlight=jerry%27s+kit

 

 

 

Don't forget the driveline is longer for the 5spd swap the trans is shorter...Jerry can fill in the details when you call him..

 

Cool.