rpiereck Posted December 10, 2008 Share Posted December 10, 2008 Anyone has an idea of how many cans of each, primer, paint (2 or 3 coats) and clear coat should be needed for a decent rattle can paint job on a Loyale Wagon? Link to comment Share on other sites More sharing options...
Uberoo Posted December 10, 2008 Share Posted December 10, 2008 What your goal in rattlecanning? do you just need some rust covered?is it a hunting/offroad rig?etc? Link to comment Share on other sites More sharing options...
Caramanos2000 Posted December 10, 2008 Share Posted December 10, 2008 I can tell you you need allot. Did this to an Old jetta and will never do it again. better off doing the Roll on Rustoleum thing Link to comment Share on other sites More sharing options...
markjw Posted December 10, 2008 Share Posted December 10, 2008 A couple summers ago I bought a cheap spray gun ($20, harbor fright) a quart of rustoleum hammer tone green ($10) and a can of acetone ($4). I read the autobody forums for an hour or so,headed out into the garage and just went for it. Yeah,it isn't winning any ribbons,but I couldn't have been happier with the results. I actually just painted outside when the wind wasn't blowing. Away from the other cars. No paint booth or anything. Link to comment Share on other sites More sharing options...
Turbone Posted December 10, 2008 Share Posted December 10, 2008 If I remember right (which isnt often) this took me about 10 cans. There is no clear coat on it, yet. Link to comment Share on other sites More sharing options...
86HatchShelby Posted December 10, 2008 Share Posted December 10, 2008 (edited) 10 CANS!? We used 6 cans of flat black to do a whole '85 GL Wagon *edit* sorry, forgot we were using industrial sized cans...bigger than normal -Jaren Edited December 10, 2008 by 86HatchShelby Link to comment Share on other sites More sharing options...
()__1337_CRAYOLA__()> Posted December 10, 2008 Share Posted December 10, 2008 it took me 12 cans to paint my brat ..... but there was alot of wind and over spray Link to comment Share on other sites More sharing options...
rpiereck Posted December 10, 2008 Author Share Posted December 10, 2008 Thanks guys. I'm looking to fix some rust on the Beater with a Heater and give her the old satin black look. I'll be doing it indoors as it's freeking cold outside (winter in Alaska...) and my garage is heated. I'll probably have to buy some cheap drop cloths or something for the floor and tool benches, but I was looking for a ballpark number of cans. 10 is a decent number. A cheap air gun might do well too, like markjw, it would be a good excuse to get that air compressor I've been flirting with... xmas is just around the corner...! Link to comment Share on other sites More sharing options...
subiemech85 Posted December 10, 2008 Share Posted December 10, 2008 MilesFox Trashwagon repaint buy a good compressor once, or one compressor every 2 years or sooner ROL-AIR is nice also use an air filter / dryer DeVilbsss sprayguns are sweet! Link to comment Share on other sites More sharing options...
offroadsubie1 Posted December 10, 2008 Share Posted December 10, 2008 my 87 wagon took 16 cans, but it was also the cheap 98 cent cans of spray paint from walmart, and it doesnt look really good, it needs to be re done with some more paint but it was also breezy and dark outside when i was painting it haha Link to comment Share on other sites More sharing options...
4WDFrenzy Posted December 10, 2008 Share Posted December 10, 2008 I wish I had pics of mine. Long story short, it worked, for the short term. From what my friend who is taking care of it says, yeah, it sucks now. But I used cheap flat black paint. Hopefully when I get back, it is getting the gloss black treatment complete with clear coat. Caleb, you need to post some pics of your paint job. It looks swell!!!! LOL Patrick Link to comment Share on other sites More sharing options...
Bucky92 Posted December 10, 2008 Share Posted December 10, 2008 5 cans of Black and 6 or 7 cans of yellow...and 5 cans of clear coat. Link to comment Share on other sites More sharing options...
ihscout54 Posted December 10, 2008 Share Posted December 10, 2008 I had spraypainted at least 5-6 trucks and countless other small body repairs, until I finally manned up and bought a gun and line dryer to go with my compressor. There is no comparison between end results. Rustolem, Krylon etc does not last, but simple fun and cheap. For a rusted ugly $200 bomber. It makes for a fun project. Link to comment Share on other sites More sharing options...
opus Posted December 10, 2008 Share Posted December 10, 2008 Even better: http://www.rickwrench.com/50dollarpaint.html Link to comment Share on other sites More sharing options...
bratman18 Posted December 10, 2008 Share Posted December 10, 2008 Even better: http://www.rickwrench.com/50dollarpaint.html That's impressive! I didn't think a roller would do that could! Link to comment Share on other sites More sharing options...
one eye Posted December 10, 2008 Share Posted December 10, 2008 Even better: http://www.rickwrench.com/50dollarpaint.html That turned out real good! Jeff Link to comment Share on other sites More sharing options...
TeamCF Posted December 10, 2008 Share Posted December 10, 2008 My 83 GL wagon took about 8 cans of the $0.99 rustolium. (by the case at HD) I still have 3 cases of flat black around here. I bought a ton as I had seen an Impreza that they used 22 cans and I planned on needing more. The Fiancee's Nova is next. (Got the shop all cleaned out for it) Advice: Don't paint it on a hot day out in the sun. The paint was boiling as it was drying on my roof and though the rest of the car has smoothed out it still looks like 80 grit up there. I knew better but picked a 100 degree day in the front yard anyway. Ah well, it's a wheeler. Link to comment Share on other sites More sharing options...
zyewdall Posted December 10, 2008 Share Posted December 10, 2008 That's a nice looking old Ford. What year? I'm going to guess '71. I've done cars with a sprayer, and with rattle cans. Can't beat the quickness and cost of the rattle cans -- about $50 for the whole thing, using about 10 cans of the good industrial stuff IIRC. But, using real car paint and a sprayer (two part urethane) sure made a nicer finish that holds up under the sun and such better. If it's a nice car, buy car paint and spray it. If it's an old beater... spray paint it. Z A couple summers ago I bought a cheap spray gun ($20, harbor fright) a quart of rustoleum hammer tone green ($10) and a can of acetone ($4). I read the autobody forums for an hour or so,headed out into the garage and just went for it. Yeah,it isn't winning any ribbons,but I couldn't have been happier with the results. I actually just painted outside when the wind wasn't blowing. Away from the other cars. No paint booth or anything. Link to comment Share on other sites More sharing options...
ihscout54 Posted December 11, 2008 Share Posted December 11, 2008 (edited) Originally Posted by opus Even better: http://www.rickwrench.com/50dollarpaint.html Thats awesome. Id like to give that a try, there's a buch of 4x4 nuts that are using fire extinguisher paint and rollin' it with good results. its supposed to be cheap and super durable. With the right ammount of wet sanding and polishing you could make stucco shine like that corvair. Edited December 11, 2008 by ihscout54 forgot to "quote" Link to comment Share on other sites More sharing options...
markjw Posted December 11, 2008 Share Posted December 11, 2008 That's a nice looking old Ford. What year? I'm going to guess '71. I don't want to get too much into it,subaru forum and all,but its a '71 frame, '67 cab and a '68 grill. I started with a bare frame and aquired parts from there.Thanks for the compliment.. The paint looked really good when I first painted it. I never did anything to protect it from UV rays. On the paint forums I was visiting,they had ideas of what I could spray on as a clear that would have UV protection and be compatible with the Rustoleum. I just never got around to it. Ive rattle canned a couple rigs,my problem was it was always blotchy. The spray gun laid it down so much more evenly.Now with my $20 investment into a cheap gun,I can paint anything for about $12. Link to comment Share on other sites More sharing options...
Truckerman666 Posted December 11, 2008 Share Posted December 11, 2008 1/2 can of zinc chromate primer, and 1.5 cans of white paint to do the passenger side door on my 87 wagon. I used real factory type paint I ordered from Paint scratch in San Francisco. It came out very nice, I am happy with it. Link to comment Share on other sites More sharing options...
Loyale 2.7 Turbo Posted December 11, 2008 Share Posted December 11, 2008 Well... I Have done Many Paint Jobs, (my recent one is my Weberized Sub into Yellow, like my Other Wagon) but I Use an Air Compressor Gun... is Amazing wht you can do with Rattle Spray cans! I Have Painted two Cars (One was my First Paint Job: a 1972 Datsun 1600 Pick Up) with Synthetic Paint (Synthetic is the Paint that comes -Ussually- on that Rattle Cans, Quarters, and Gallons) and that Paint gives Great Results, the only Problem with that, is that Synthetic Paints trend to loose -fade- the Shine... in around one Year... Well it Depends on Weather, sun, etc... Nice Cars! ... I Like the Ford, the Brats and the Flat Black Impreza, I Believe that Flat Black is a Good Choice; All Looks with Very Well Done Paint Jobs! Link to comment Share on other sites More sharing options...
cd45 Posted December 11, 2008 Share Posted December 11, 2008 Here is my '87 GL. I liked the idea of an OD green car. It took me about 10 cans because it was very cheap paint. This pic was taken after I installed the 14" Nissan wheels. Link to comment Share on other sites More sharing options...
idosubaru Posted December 12, 2008 Share Posted December 12, 2008 i posted a long time ago here and on the XT forum pictures of a guy i knows mazda - the 64 dollar paint job i believe was the title of the thread. you can search here or the XT forum. it's quite an amazing 64 dollar paint job. i tried to talk him out of it "waste of time"...etc, he was still happy with it a few years later. granted, not a spray job but you'll be amazed at the picks. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now