Jump to content
Ultimate Subaru Message Board

gen3 headlights only work while holding dimmer in rear flash position


Recommended Posts

yes, that's right headlights worked fine before car was shut off for about 1/4 hr, but when restarted, headlights did not turn on unless dimmer switch held in the rear - "flash to pass" position - so I had to drive home about 5 miles and 10 minutes with my middle finger on the trigger :-\

I tried restarting car, and turning switch several times, always :dead:

Link to comment
Share on other sites

Nothing in the forward position either? I had that happen once, where the low-beam relay went out, but the hi-beam relay was still working, so forward and pulled back, the hi-beams worked, but no lo beams in the normal position. But if the hi-beams don't work in the forwards position, then it sounds like the switch itself died somehow, not the relay.

 

Z

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...