Uberoo Posted December 18, 2008 Share Posted December 18, 2008 If I was to put a subaru or any other unibody car on a solid axle toyota frame,How much would that lift said subaru/unibody? With the stock tires on the toyota running gear. I have access to a toyota 4x4 solid axle rolling chassie. So just wondering... Link to comment Share on other sites More sharing options...
The Beast I Drive Posted December 18, 2008 Share Posted December 18, 2008 Ask Monstaru, he did it, just never finished it... -Bill Link to comment Share on other sites More sharing options...
one eye Posted December 19, 2008 Share Posted December 19, 2008 (edited) You would have a stock toyota with a subaru body on it. If you don't lift it, it would just look like a toyota pickup with a subaru body. Might try this forum http://www.toyotanation.com/forum/forumdisplay.php?f=81 I've seen people do it with honda's and stuff, maybe somthing there about it. Jeff Edited December 19, 2008 by one eye Link to comment Share on other sites More sharing options...
mcbrat Posted December 19, 2008 Share Posted December 19, 2008 from here... http://www.rrr4x4.com/Jayson.html Link to comment Share on other sites More sharing options...
monstaru Posted December 19, 2008 Share Posted December 19, 2008 its huge.where you run into issues is with the body mounts on the toyota frame,you almost just want to weld crossbars from side to side.but then it is really ridiculous.it takes a little finesse to get it to match up right as it sits. but if a guy were to shorten it in the center where the transfer case crossmember was, it would be easier maybe. it is defenitely fabbing eve3rything.nothing matches up.i got it all lined up and attached at a couple of points then got rid of that project.cheers, brian Link to comment Share on other sites More sharing options...
Andy FitzGibbon Posted December 19, 2008 Share Posted December 19, 2008 To make it sit any lower than in that photo, you would have to cut out a lot of the unibody/uniframe. Guys used to do that with Ford Pintos when I was growing up, and ran into the same issue. Andy Link to comment Share on other sites More sharing options...
Uberoo Posted December 19, 2008 Author Share Posted December 19, 2008 (edited) so then it should be able to clear 33"s then?was that frame lifted any to start with? Edited December 19, 2008 by Uberoo Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now