92loyale Posted February 7, 2009 Share Posted February 7, 2009 So, tonight at work I notice I'm dripping some oil. Well, I look down and don't see anything unusual so I look under the car. My darn oil filter is rubbing on the electric fan bracket. What the heck could have caused this? The radiator hasn't moved. I;m thinking the tranny mounts? Maybe they went bad allowing the engine to tilt up? Not sure. Anyways, just out of curiosity I was online looking up parts, No listing for tranny mounts? ODD.... 1992 Loyale 5spd S/R. Link to comment Share on other sites More sharing options...
Snowman Posted February 7, 2009 Share Posted February 7, 2009 Are you sure the rad hasn't slipped from its lower mounts, or that the mounts haven't deteriorated enough to allow movement? I've seen this happen twice on different cars. One time, it did exactly what you describe and rubbed a hole in the oil filter. The other time, the rad came back into the belt-driven fan, which chewed up the rad. Link to comment Share on other sites More sharing options...
92loyale Posted February 7, 2009 Author Share Posted February 7, 2009 I'm going to go check that here in a few minutes. I just put the engine back in and than the rad. I didn't notice anything out of the ordinary. Although when I pulled the rad out, there was no lower mounts. Just the two screws on the top the were holding it up. Oh, it did rub a hole in the filter. Link to comment Share on other sites More sharing options...
hooziewhatsit Posted February 7, 2009 Share Posted February 7, 2009 There should be two studs on the bottom of the radiator that fit in their respective holes in the cross member. If it's just held in by the two upper bolts, that could cause a problem Link to comment Share on other sites More sharing options...
ShawnW Posted February 8, 2009 Share Posted February 8, 2009 Maybe the pitch stopper wasnt installed? Its a bracket that holds the engine/trans to the firewall basically and prevents the motor from tilting forward. Might even need adjustment. Link to comment Share on other sites More sharing options...
92loyale Posted February 8, 2009 Author Share Posted February 8, 2009 Thank you all for your input! Seems as though when I put the engine back in and than the radiator I wasn't paying attention or something. The rad wasn't put all the way in the lower area. I unbolted it than got it into the correct place. Well, off to the store for some oil and a new filter. Shawn, were you by any chance in Colorado Springs over the summer at the pick and pull yard? Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now