The Beast I Drive Posted February 26, 2009 Share Posted February 26, 2009 Cool cool man -Bill Link to comment Share on other sites More sharing options...
SubaruWagon87 Posted June 12, 2009 Author Share Posted June 12, 2009 Alrighty, now that I'm finally ready to start workin on the wagon again, I have one question, what would be the best way to clean out the heater ducts (without removing them)? Or do I have to remove them? I only ask because I'm a little paranoid about haunta. That and I want both my girlfriend and I to feel safe when I blast the fan. Link to comment Share on other sites More sharing options...
The Beast I Drive Posted June 12, 2009 Share Posted June 12, 2009 Pull the vent grills off and stick the shop vac in there, and also unbolt the fan housing and vacuum out down there too, make sure you cycle through the HVAC controls while you do it. I had a bad vibration in the heater fan in my RX, so I took the housing out, and low and behold there were 2 dead mice stck in the viens of the fan! Once i got those out it ran nice and smooth... -Bill Link to comment Share on other sites More sharing options...
SubaruWagon87 Posted June 12, 2009 Author Share Posted June 12, 2009 I'll try that sometime. Would using compressed air be a bad idea? Link to comment Share on other sites More sharing options...
The Beast I Drive Posted June 12, 2009 Share Posted June 12, 2009 Vacuum first, then compressed air and vacuum again -Bill Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now