Jump to content
Ultimate Subaru Message Board

Recommended Posts

my gt came with this wireless entry unit. it was hanging down, lots of loose wires and no remote. i decided to remove it. when i took it out, the driver door no longer operates with the electric locks. anyone know how to restore this to the original wiring setup without the entry unit??

 

MVC-001S-2.jpg

 

MVC-002S-2.jpg

Link to comment
Share on other sites

If I had a wiring diagram for the keyless entry I could tell you.

 

What year? I'm assuming it's a Legacy?

 

97 legacy GT, auto

 

it appears as though there was a label(?) glued on the back of the unit. it may have been a diagram but i don't know, it's gone. any one have a wiring diagram for this?

 

thanks

Edited by johnceggleston
Link to comment
Share on other sites

John:

 

I have the full install book and It will show the wires you need to reconnect to restore the system to normal operation.

 

Get me your address and I will send you a copy. It is too large a file to email in PDF

 

Mike

Link to comment
Share on other sites

I have a spare replacement remote. I purchased 4 of them off Ebay and only used 2 so far. $25 shipped.

 

I put one of these in on a 96 GT and it needed the additional Driver's door actuator installed. The car did not come with the electric door lock on the drivers door.

 

You might want to check under your door panel and see if that is the case.

Link to comment
Share on other sites

I have a spare replacement remote. I purchased 4 of them off Ebay and only used 2 so far. $25 shipped.

 

I put one of these in on a 96 GT and it needed the additional Driver's door actuator installed. The car did not come with the electric door lock on the drivers door.

 

You might want to check under your door panel and see if that is the case.

 

pm sent

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...