Jump to content
Ultimate Subaru Message Board

85 BRAT exhaust with lift redo


Recommended Posts

Have an appointment at the muffler shop tomorrow to pull the exhaust back up nice and close to the body, since my 4" lift dropped it down.

What advice should I tell the muffler guy. I am not really getting a total new exhaust, mine is still good, just needs fastened back up out of the way and not hang so low.

 

What did you guys do to put it back up toward the body after a lift kit?

I stopped for a quick estimate today, and he asked if the middle section was a cat or a resonator. I think the CAT is up front, and it would be a resonator, should i ax that resonator if I can ? please advise by the AM.

 

thanks

Link to comment
Share on other sites

the middle section is a resonator. just 1 single cat in the Y pipe if stock.

 

they'll probably just cut and add a bend after the Y pipe to take the whole thing closer to the body....

Link to comment
Share on other sites

okay its all done now.

cut off the oem after the y pipe, 1/8" larger than stock tubing tucked back up into the body, re-using the stock midpipe resonator, then new 1/8" larger than stock pipe, going into the stock muffler. tucked up nicely.

cost 99 plus tax, 106.xx total

 

too bad this will only be useful for a few years, then the ej22t swap will need some 3" in about 4 years

 

now, still need to locate 32/36

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...