oooo Posted June 17, 2009 Share Posted June 17, 2009 those of you that have lifted your dual range subarus and run atleast 27 in tires or larger. How is the power and acceleration when in low range. Will it hurt the transmission to just keep it in low all the time, so car is not as slow as a snail. I have a new 97 impreza with the manual 3.9 and have 27.5 inch all terrians and its pathetic when accelerating. I was gonna swap in the 4.11 out of an outback but if I can swap in the 3.9 with low range and just keep it in low all the time I might do that. That way I will have a locking center diff. Also does anybody know what the 3.9 in low range is equivalent to. Is it close to 4.11 gearing? Thanks in advance Link to comment Share on other sites More sharing options...
Scott in Bellingham Posted June 18, 2009 Share Posted June 18, 2009 on a dual range transaxle you can run it in fwd low range just need to remove the short linkage from the front of the trans to the rear thats the hi/ low then just leave it in low or make 2 seperate linkages Link to comment Share on other sites More sharing options...
Numbchux Posted June 18, 2009 Share Posted June 18, 2009 I don't think running it in low is going to hurt anything, specifically. But, running it in 4WD will. As scott mentioned, though, it is possible to separate the linkages, and run it in 2WD Lo. Link to comment Share on other sites More sharing options...
TeamCF Posted June 19, 2009 Share Posted June 19, 2009 Do the dual stick mod as mentioned and just use lo/1st as your first gear. Shift to hi for "second" then use you gear shift as normal. Sounds wierd but I've noticed that the lo range is really just like having one more first gear under the hi range first. (at least in some experimental driving on gravel roads it certainly feels that way.) (note it actually changes all the ratios as the lo range does it's reduction before the power enters the rest of the tranny, poke around, you'll find more info on it) So you don't have to drive around all the time in lo, just use it to get going. If that makes sense... Link to comment Share on other sites More sharing options...
backwoodsboy Posted June 19, 2009 Share Posted June 19, 2009 (edited) Its never bothered MY 4-spd, and I run in low all the time. (2WD lo) I did the 2WD LO mod on my lifted brat about 2 years ago. With my 29's I NEEDED it! Anyway, I have found that 1st lo IS excellent for starting off without having to slip the clutch. However, there ARE perks to using LO in the higher gears that were not apparent at first. For long, steep hill climbs for instance... Lo range 2wd gives you "shorter" gears, and with that some considerable advantage. For accelerating on long flats, HI range 2wd is best as it gives you taller gearing, therefore FASTER accel. Edited June 19, 2009 by backwoodsboy Link to comment Share on other sites More sharing options...
The Scooby Posted June 19, 2009 Share Posted June 19, 2009 i drive around A LOT in 4wd on my 27inch SSR's and have yet to have any issues. but i did break a rear axel the other day doing doughnuts in a field, go figure. Link to comment Share on other sites More sharing options...
Andy FitzGibbon Posted June 24, 2009 Share Posted June 24, 2009 Also does anybody know what the 3.9 in low range is equivalent to. About 6.20:1, so quite a bit lower than 4.11. Andy Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now