Jump to content
Ultimate Subaru Message Board

Lack of power?


Recommended Posts

Why do I keep losing power going uphill? Note the flow direction of the honeycomb (and the fact its "free" and making its way down the pipe). Twice this has happened on my EA81, I hate cats. Replace with 18" of straight pipe, done.

l_0ce232db6e574349b6172c29ff55143e.jpg

Link to comment
Share on other sites

Well... I Had that Problem Long time Ago... Found Restrictive Flow in the "Y" the Cat and Also inside the Muffler...

So I Changed the Whole Exhaust Pipes with 2" and Removed the Three Filters (the Cat, the "Y" and the Muffler) instead of Muffler my Subies got an Empty Can, but Filled with Fiberglass Noise & Heat isolating (industrial Grade) Compound, so it Won`t be a Fartcan...

Link to comment
Share on other sites

7Point62, sweet name,

If youre going to cut it open and gut it, remove the exhaust and do it from the top, so IF you do have to get an inspection it wont be noticed. Cutting and opening is the best way to make sure you got it all out.

 

As far as gas mileage goes, I don't know. I dont have a fuel gauge or a properly working odometer yet. GD would know.

Link to comment
Share on other sites

You might pick up a few MPG if the cat is clogged or broken and jamming the outlet of the chamber. If it's not then you won't gain a thing. I run about 75% on them having some sort of issue that I wouldn't have known about had I not opened them up. So I don't even bother trying to save them anymore. If I needed a cat for some reason (I don't smog my rigs) then I would buy an aftermarket cat off ebay for $60 and weld it into the mid-pipe. The stock 20 year old cat is too much of a gamble IMO. Better to open them and know where you stand.

 

I always cut about a 6" sqaure out of the cat on the top, gut the internals, then weld the flap back on. It's all hidden under the heat sheild and they weld real nice as they are stainless.

 

GD

Link to comment
Share on other sites

All the scavenging you need is done in the stock header - before any cats. The cats should flow as freely as possible.

 

If you think you might be down on mileage and can't find any other reasons - it's worth a look inside the cat. I picked up about 3 MPG when I opened up the cat on my '83 hatch. The contents were completely gone and the metal brackets and mesh screen were wadded up in the outlet. Bumped me up to 26 MPG from about 23 (engine has a low comp. cylinder).

 

GD

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...