987687 Posted February 5, 2011 Share Posted February 5, 2011 ti fixed my rear camber issue on the drivers side rear tire. its rediculous how much the slack in those swing arm holes changes the geometry of your tire. Those are a pain in the rump roast... Link to comment Share on other sites More sharing options...
Nomad_Brad Posted February 5, 2011 Share Posted February 5, 2011 spent couple hours under the hood, but I was just scrubbing up the engine bay, looking pretty clean! Also placed order rock auto, plugs,wires,air filter, disty & rotor...hopefully help MPG...... -Nomad Link to comment Share on other sites More sharing options...
1-3-2-4 Posted February 5, 2011 Share Posted February 5, 2011 Put in the new clutch cable last night and changed the oil this morning.. Now just waiting on some parts from subaruparts.com to arrive. Link to comment Share on other sites More sharing options...
tforce Posted February 6, 2011 Share Posted February 6, 2011 Pulled the engine out of my 95 legecy and R&R'd all the oil seals, resealed the oil separator cover, new water pump and thermo, timing kit, oil pressure sender, inner pass side timing cover. Got the engine back in and it wouldn't run for SH(#. I'd start it up and it would run rough (missing) for a few seconds and then die. CEL was on and would start flashing if I tried to rev it up. Turns out that water had pooled around the spark plugs when I hosed off the top of the engine to clean off all the oil from the leaking Oil PS.....Ooops. Runs great now but I forgot to shift the timing tension plunger to the left before I pulled the pin. And I maybe should have replaced the driver side HLA's but the tick really isn't that bad. Link to comment Share on other sites More sharing options...
kanurys Posted February 6, 2011 Share Posted February 6, 2011 Got the replacement mirror put on the outback. Also made progress with my gps. I have to make a power regulator for it and then throw it in for some testing. I think the 20x4 lcd will fit great in place of the dash clock on the GL. Link to comment Share on other sites More sharing options...
hanyou Posted February 6, 2011 Share Posted February 6, 2011 Replaced a nasty vacuum line on my GMC Jimmy with leftover good lines pulled from the Brat during its Dgevification. Troubleshooting the non starting Jimmy led to a bad distro rotor. Works now, and got me to check the Brat distro, which needed some help as well. Both running better than before ^^ Heater/AC wont start after I installed my radio.. tapped into a keyed 12v but it shouldnt have knocked it out. No fan (any setting) or any heat/ac activity from the engine bay either. Time for more sleuthing Bed is being sanded for some bed liner as a rust preventative. Old owner did the undercarraige so no worries there at least. Working on a 2nd Brat or 1st Loyale, have a friend converted to get either but nothing cheap enough yet. His wife hates both, but he has her conviced on a Outback at least, so one way or another theres another Soob on the way ^^ Link to comment Share on other sites More sharing options...
b88185 Posted February 6, 2011 Share Posted February 6, 2011 Installed D50 wheels with Falken Radial AP's, 4runner struts in back and more preload up front! Link to comment Share on other sites More sharing options...
987687 Posted February 6, 2011 Share Posted February 6, 2011 I like the different shades of blue you have going on there. Link to comment Share on other sites More sharing options...
TheLoyale Posted February 7, 2011 Share Posted February 7, 2011 I like the different shades of blue you have going on there. This car is pretty nice in person, and it also has a Weber swap! Link to comment Share on other sites More sharing options...
b88185 Posted February 7, 2011 Share Posted February 7, 2011 I like the different shades of blue you have going on there. nothin but class Link to comment Share on other sites More sharing options...
Ricearu Posted February 7, 2011 Author Share Posted February 7, 2011 Took the foz off roading in the snow Some Jerkov in a 80's F-150 attempted to make a left turn from the right lane, right in front of me, I honked and chose the ditch vs. his p.o.s. STEEL truck that probably wasn't insured anyways. Lucky a nice guy in a jeep pulled me out. Refused to take cash, said he was out pulling people out for 3 days just for fun I wish I could do that! Luckily the FOZ is ok. Link to comment Share on other sites More sharing options...
xman Posted February 7, 2011 Share Posted February 7, 2011 There's no reason you can't pull people out with your Forester. Get a tow strap. Link to comment Share on other sites More sharing options...
987687 Posted February 7, 2011 Share Posted February 7, 2011 I've pulled people out with my legacy and my GL. Get a quality tow strap. Link to comment Share on other sites More sharing options...
TheLoyale Posted February 7, 2011 Share Posted February 7, 2011 I've pulled people out with my legacy and my GL. Get a quality tow strap. Get some decent tires for a start, if you got stuck in that little bit of snow/mud, then you need better tires. Link to comment Share on other sites More sharing options...
Goobysoobs Posted February 7, 2011 Share Posted February 7, 2011 (edited) heh I've pulled people out as well with my legacy but I think he was saying he wished he could pull people out for 3 days just for fun lol. Well I haven't done anything to my 90 legacy yet (besides clutch and timing kit) but I got hit by a drunk driver last night and now need to replace pretty much all the passenger side rear quarter + the bumper he ran off on foot and i think they ended up getting him but have to wait for a week for my insurance to get the police report, the good thing is I do have unisured/underinsured property and medical coverage so if it ends up being bad with him and no insurance I can do that though it's a $500 deductable. Other than that bad news I do plan on lifting it with some outback struts and springs and putting some 16" steelies on it from a forester or outback. Edited February 7, 2011 by Goobysoobs Link to comment Share on other sites More sharing options...
81EA81 Posted February 7, 2011 Share Posted February 7, 2011 I cleaned up the pcv system on the 86 Brat, The T coming from the pcv valve to the left valve cover/air cleaner was completly cloged up with 25 years of nasty carbon. the hoses were almost completil clogged too. also changed the fuel filter before the fuel pump Link to comment Share on other sites More sharing options...
92_rugby_subie Posted February 8, 2011 Share Posted February 8, 2011 I have done A LOT on Ned since I last posted Few days ago, Spencer, OBK25XT put a 2.5 inch muffler on the car. Sounds great! Just did oil change/filter change Link to comment Share on other sites More sharing options...
Ricearu Posted February 8, 2011 Author Share Posted February 8, 2011 (edited) Lemme rephrase that, I wish I could have stayed home from work and pulled people out for 3 days... lol! and I have NEW Cooper tires on it, but they are passenger all seasons. no use getting I pikes or blizzaks down here. unless the world freezes over. Also, the snow isn't what got me, Its hard to tell from the photos but my roof line was about level with the road, it was a decently steep embankment. This is texas btw, it snowed over mud, the snow stayed put but the ground underneath wouldn't freeze. It tried like hell though, but only slid sideways. Makes me REALLY wish I had the cash to put A/T's on the GL, it's got a wench but the tires on it are Toast Edited February 8, 2011 by Ricearu Link to comment Share on other sites More sharing options...
987687 Posted February 8, 2011 Share Posted February 8, 2011 Love my snow tires. I'm addicted, I couldn't run another winter without them. But then, I live in Maine... I drive on roads that are impassible without snow tires and 4wd/awd in some conditions. My driveway is one of them... Got the engine in my GT ready to pull, everything disconnected (pretty much). Didn't have it in me tonight, so I'll get a fresh start at it tomorrow. When I warm up a bit I'm going back out to get the timing belt on the ej22 swap engine. I can't wait to have it running! Link to comment Share on other sites More sharing options...
TheLoyale Posted February 9, 2011 Share Posted February 9, 2011 L-shaped door pulls! OMG it looks sooo fabulous! Link to comment Share on other sites More sharing options...
92_rugby_subie Posted February 10, 2011 Share Posted February 10, 2011 Ned is sitting on his donut that was donated by Spencer... No flat tires. I just decided to pull off the rim, check the castle nut (separate posting) and paint the wheel... Heres before pics of the 4 rims, and a finished picture of one, I still got 3 to do though Link to comment Share on other sites More sharing options...
987687 Posted February 10, 2011 Share Posted February 10, 2011 Got the ej22 swap in my LGT running tonight. Tomorrow I'll hook everything up and put in coolant and stuff. Just wanted to hear it run so I could go to bed knowing that engine worked. Link to comment Share on other sites More sharing options...
92_rugby_subie Posted February 10, 2011 Share Posted February 10, 2011 Congrats Ive helped Rick with that swap before, lady ran the 2.5 outta oil Link to comment Share on other sites More sharing options...
Ricearu Posted February 10, 2011 Author Share Posted February 10, 2011 Congrats Ive helped Rick with that swap before, lady ran the 2.5 outta oil That sucks, especially when the 2.5 chunks rods for fun, even full of oil Link to comment Share on other sites More sharing options...
92_rugby_subie Posted February 10, 2011 Share Posted February 10, 2011 Today I am continuing my, one wheel at a time project... Just mounted the wheel back on Ned, I didnt think the difference was soo..... hmm intense.. lol. Itll be even more intense when I get access to a wire wheel and can grind down the lugs and paint them Im thinking white (to stand out on the black) or possibly red (again, to stand out on the black) Before/After: Ned with wheel mounted: Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now