Jump to content
Ultimate Subaru Message Board

mam147

Members
  • Posts

    6
  • Joined

  • Last visited

  • Days Won

    1

mam147 last won the day on October 5 2013

mam147 had the most liked content!

Profile Information

  • Location
    Argentina
  • Vehicles
    Subaru GFT-5 Coupe

mam147's Achievements

Newbie

Newbie (1/11)

5

Reputation

  1. As Loyale said, i'm not able to found a factory intake manifold with single carb for EA71 because that model not arrived to this country...just EA71 1600 5 speed MT (2wd) and EA81 1800 on the 80's The same for the Brat's...not arrived here No, I wanna keep them...just in case that I need it in the future or if I want roll back the weber setup to keep the car as original.
  2. Hi im back after some months of work and search for a dual carb intake manifold. I found one and sent it to a factory to perform the modification from dual carb to a single weber carb...below are the results... I've the car running with the weber for a month, is another car, runs great and has more acceleration but I noticed that the fuel consumption is very high, i think that the weber has the jets (fuel and air) for a 1800. it's gave me about 12 liters per 100 km (with A/C on). I'm looking for the correct set up jettings for a EA71 1600, any ideas?
  3. Hi Willy, thanks for your reply!! Can you send me some pictures from your intake manifold please? Thank you! Regards. Mariano
  4. Hi Guys! First off all, thanks so much for your comments and assistance on this trouble. I don't know how the intake manifold from EA63 looks like, if you can provide a picture, I'd really appreciate it. On the other side before proceed to search and buy another intake manifold, need to confirm with some of you, the final lenght of it, i.e the factory intake manifold has 51,8 cm between cylinder heads where the manifold is connected to them. Another point to consider on this, is that the EA71 cylinder heads are not in line, what I mean if you take a look to the following pictures, you can appreciate that the factory intake manifold has a little curve on the driver side. The manifold that I bought from EA81 is straight, for this reason need to know if the EA63 intake manifold has the same format that the factory manifold. Regards! Mariano
  5. yes is the original red paint....another pic inside the cover during a hard clean on the engine. Regards!
  6. Hi guys, I'm from Argentina and would like share some pics of my Old Subaru GFT-5 1980, EA71 engine twin-carb Hitachi...
×
×
  • Create New...